ALL nokia BB5((Nokia New Models) Security code or lock codes 100% Update!!!

Hello, I can give you your LOST security code (or lock code is one and the same thing) for all BB5 phones:

3250, 6131, 6133, 6125, 6126, 6270, 6280, 6282, 6630, 6680, 6681, 6682, 7370, E60, E61, N70, N70, N72, N80, N90, N91, N92, Also new models N73,N95, 5700 XM, 6300,N82 ETC

NOTE: PHONE SHOULD NOT BE ALREADY LOCKED!!!!!
However if the phone is ALREADY LOCKED then start in Test mode or Local Mode and then follow the Steps mentioned below!

To sart in Test Mode when phone is Locked look here:

How to start your Locked Phone in Test Mode TUTORIAL!!!

Tutorial is for Already Locked Phone by Security Code or Lock Code and When you don't have a RJ45 cable or which is not Modified!!!!!!!
What is Test Mode ?
Nokia has three modes of working :
Normal Mode
Local Mode
Test Mode

Now when your nokiaphone is ALREADY LOCKED WITH SECURITY CODE it does not get connected to the PC through its supplied Dku2 cable. As the phone blocks the functioning of its usb pin and pc does not detect any USB device.

Now in that case if you start your phone in Test or local Mode, PHONE GETS CONNECTED TO PC VIA DKU2 (your supplied usb cable) and hence can be used or repaired my any software like mt box, jaf or nemises suit.

So then you can perform all operations on it without even formating , like:
-RESET YOUR SECURITY CODE
-GENERATING PM FILE
-GENERATING ASK FILE
-FLASHING (formats everything)

NOTE: This tutorial is not for Newbies So please if you don't know what this is all about, I advise you to go to any local phone repairing shop and asked them to switch on your phone in test mode instead.

However, if you will follow everything as I said nothing should go wrong

Now How to do it ???
You will need an external power supply as shown in the picture.it can be found on most repairing labs. You must have also seen it in your college electronics lab LOL.


Now if you have got any external power supply with its all three crocodile connecting wires(red, black, green) well and good. Then follow Section 1 or else if you have got a power supply with just two wires red (positive) and black (negative) then move to Section 2

Section 1:

1. Remove the original battery of the phone.

2. Out of the three battery connecting terminals on the phone, find out which is the positive, negative, and temporary battery terminal by matching it with the positive and negative and a blank or a circle sign made on your Nokia battery.

3. Now connect the positive `terminal of the phone with the red crocodile and negative terminal with black crocodile and the third terminal on the phone with green crocodile (as shown in the picture)

4. Now switch on the external power supply with voltage about 3.7 V or as mentioned on your Nokia battery with mAh readings

5. Now power on the phone and wait for few seconds and you will see on the screen as "TEST MODE" or as "LOCAL MODE"

HOPE IT HELPS, THANK YOU
SECTION 2 :

Step 1 and Step 2 are same as Section 1

3. Now connect the positive term point of your phone with the red (positive) crocodile and negative point with the back crocodile(negative).

4. Now for the third left over point at your phone, You have to buy a 4,7k resister wire. Connect it with the phone third temporary terminal from one end and the other end with any old nokia battery's negative terminal .

5. Now switch on the external power supply with voltage about 3.7 V or as mentioned on your Nokia battery.

6. Now power on the phone wait for few seconds and you will see on the screen as "TEST MODE" or as "LOCAL MODE"

HOPE IT HELPS, THANK YOU...........